Принтер лазерный Samsung Xpress M2020, ч/б, A4 — 2344 отзывов, плюсы и минусы
2344 отзывов пользователей о Samsung Xpress M2020, ч/б, A4
Пользовались
Samsung Xpress M2020, ч/б, A4?
Поделитесь своим опытом и помогите другим сделать правильный выбор
I cannot understand why some websites say to put in 3 screws in place of the plastic rivets. When the side snaps in, it is in tightly and screws are NOT necessary. Just put the cartridge back in and you are done.
This was only a 5 minute job to do. The toner quality is excellent. Highly recommended way to save some money for the refill.
(1) on the chip side of the cartridge, there are 3 dome-looking plastic rivets. I didn't have a dremel and my box knife was a bit too big to remove them. So, I cut as much as possible, then inserted the edge of the box knife blade at the end cap interface and wiggled it until it popped off.
(2) Remove the about 1/2" dia toner res cap
(3) Added toner, replace toner res cap
(4) Replace end cap back, pressed down and it seemed to snap and then hold - didn't need any screws.
(5) didn't replace chip, so have stored that for another day
(6) printed!
Sure beat the OEM replacement cartridge price.
-1 star because the included instructions were lame.
2 Star part - The refill kit had a 100 grams toner (OK - 65 grams needed); a pour spout (OK); a rubber glove (OK); cartridge hole cover tape, not required on my cartridge; replacement chip included. NOT INCLUDED: 3 small (#2 x 3/8" ?) screws to re-fix the cartridge end cap.
-2 Star - Lame Instructions - If you have a digital camera, take photos as you go, so you'll have a record of the work. THIS WILL BE YOU INSTRUCTION MANUAL IN THE FUTURE. Can't imagine the vendor will ever be helpful.
To refill this cartridge, you first remove the 3 melted plastic rivets on the right side / chip side of the cartridge. I used my Dremel Moto tool with tiny conical diamond grinder bit (Harbor Freight, cheap set)to first drill a hole in the center of each rivet. Then, I used a cylindrical diamond grinding bit to gently grind the rivets flush with the cartridge side. Go slow, be careful, as the plastic grinds quickly and easily. Once the rivets are removed, gently remove the cartridge end cap.
On my cartridge, the REFILL HOLE is exposed. Use a small pair of pliers to remove the refill hole plug, and set aside. Use pour spout to add toner as needed. Replace hole plug. Shake side to side to distribute toner. Replace the chip. Gently replace the end cap and fasten with 3 small screws. Re-install cartridge in printer and make a test print.
If your cartridge doesn't have a refill hole, you have to buy a hole tool on line, basically a tube heated by a 30 watt soldering iron. If I had to make a hole, I'd get a piece of 1/2" metal tube, heat in a stove flame, and carefully melt the hole in the cartridge.






