Принтер лазерный Samsung Xpress M2020, ч/б, A4 — 2344 отзывов, плюсы и минусы
2344 отзывов пользователей о Samsung Xpress M2020, ч/б, A4
Пользовались
Samsung Xpress M2020, ч/б, A4?
Поделитесь своим опытом и помогите другим сделать правильный выбор
1) it is not clear where the location of the hole should be - very poor quality illustration on the procedure sheet.
2) Drilling this hole will result in plastic shavings ending indside of the tank. These shavings will be electrostatically charged and therefore hard to remove. The shavings will cause failure of the unit, most probably becasue they will damage the surface of film material.
I instead used procedure from YouTube video - removing the side panel and refilling from there. No fus, no problems, no mess. Printer works just fine.
Easier to cut end of nozzle to allow more flow out of the bottle. See U tube: [...]
for instructions. I just snapped the end over the old rivets, IE. did not cut them off as suggested. No screws were included.
I also put in the new chip as recommended.
Jim
http://www.youtube.com/watch?v=1lmJVIW1z9c
Easy instructions:
---Before step one, throw out the TERRIBLE instructions that came with the product. They are nonsensical.
(1) Take a razor blade and cut off the three plastic rivets on the side with the chip.
(2) Pull off the cap. If you have problems, use that razor blade to cut between the cap and the cartridge to make sure the rivets aren't holding, and pry it up.
(3) You will see a rubber cap inside covering the cylinder that holds the toner. Pop it off.
(4) Carefully pour in the toner. Use the included funnel cap, and cut it low so that it has a wide opening. As you pour it in, tap the cartridge to level out the toner.
(5) Put the cap back on. Sway the cartridge back and forth to even out the toner.
(6) The chip slides out pretty easily. You can use a small screwdriver if necessary for this part, but be careful.
(7) Slide in the new chip in the same direction. The cut out corner should be facing the inside right of the cap.
(8) Replace the cap and start printing! You don't need to put screws on or anything. If you did it correctly, the cap should stay on by itself.
I normally don't write reviews for products like this, but it did a great job!
I came back to upgrade my review. The seller was VERY responsive to my chip issue, and sent me two newer chips to try. The printer had finally gotten tired of nagging and just stopped printing shortly after they came, so it was a great relief to pop one into the cartridge and have the printer give me the GREEN light! As I mentioned above, the toner has always worked great. Thanks!
1) no problem with toner
2) works with no difference from original
3) some amount left over
my cons:
1) after refilling toner, my pc still alerts what toner is over, but it might be Linux Mint (Ubuntu) related issue which configured via Wi-Fi (over http). but who cares :-)






