Принтер лазерный Samsung Xpress M2020, ч/б, A4 — 2344 отзывов, плюсы и минусы
2344 отзывов пользователей о Samsung Xpress M2020, ч/б, A4
Пользовались
Samsung Xpress M2020, ч/б, A4?
Поделитесь своим опытом и помогите другим сделать правильный выбор
The refill process is easy, but can be somewhat messy. Look up "D104s toner refill" on any popular video site to find video tutorials. You will need a sharp knife - I used a box cutter - and that's about it. Everything else is included with the toner. Keep in mind when you are prying off the cartridge end cap you are actually fracturing whatever's left of the 3 plastic rivets, so yes, be gentle, but firm and make sure you trim off as much of the rivets as possible to make it go easier.
I recommend a pair of disposable gloves and a clean work surface, but that's up to you.
Also, don't squeeze too hard on the toner bottle when decanting into the cartridge, the seal on the bottle isn't very good and it will squirt through the cap. This may have been my fault though. At any rate, just gently squeeze and tap the toner bottle until it's all through the nozzle. It'll take an extra minute or two, but you'll get all the toner into the cartridge instead of all over your work surface.
Print quality is excellent, certainly better than the OEM toner that came with my printer.
However, the toner doesn't bake on to the paper very well and eventually rubs of a little too easily. Will probably use factory toner next time.
Print quality is definitely not the same. For general office use and an occasional spreadsheet to share with someone else it is absolutely fine. But it does not give the same vivid black as my old OEM cartridge. I would not use this for something I was giving to customers or my board of directors!
So far it's doing well. I will update the review after I run through a few more print jobs.
Works well so far. I didn't think the screws were necessary so I just put the toner cover back in securely and snapped the end cap (where the chip was installed) back. Where the cartridge sits also will keep the ends in place anyway.





