Отзывы о Блок питания AeroCool KCAS PLUS 1200GM 1200W
169 отзывов пользователей o AeroCool KCAS PLUS 1200GM 1200W
Пользовались
AeroCool KCAS PLUS 1200GM 1200W?
Поделитесь своим опытом и помогите другим сделать правильный выбор
Plus all your usual SATA, molex and motherboard supply
The Aerocool was a good price for a similar spec, much lighter.
But it's quiet and keeps the i5-4460, Z97 board, SSD's and 750 Ti running along daily.
The size of the fan was really important because I have a Corsair 600T case, which is a couple years old but still meets any of my upgrades needs, including installing a new fan; however, the space for the front 200mm fan is very tight. Directly behind the fan are the drive bays, which contain five drives, so I need a good intake fan to keep the area cool. Because of the limited space, I had to have a fan with a width of no more than 20mm, or less than one inch. After looking over the fans on Amazon, the AeroCool was one of the only ones that meet the criteria of width, low noise, and blue LED.
If you are considering either the Cooler Master Mega or the BitFenix 200mm fans make sure your case has is big enough to house these thicker fans, because my case definitely could not accommodate either one.
The installation of the AeroCool fan was much easier than I expected because with the 600T case you can slide out the entire drive bay to access the fan. The screws on the AeroCool matched up perfectly with the factory installed 200mm fan and aside from having to tighten the screws on the front panel at a slight angle, it all worked out.
The AeroCool fan is a quiet fan when running at 50% to 60% of its maximum, any faster and you will hear the fan, though it is not too loud.
I would definitely recommend this 200mm case fan for all the reasons I mentioned above.
Bought 2 of these for my RV refrigerator cooling on the outside. Originally there were 2 small computer type fans that were really noisy and could be heard form the inside. Tired of the noise and wanted quiet, I installed the AerCool fans about the same location so that they would blow across the fins and push the heat out. Do they work? I used to have to put the refer cold setting at four, now I can set it at three and have the same cooling capability. So, yes they work well and I have no noise to put up with.
The screws fit poorly, and since the chassis screw holes dont come pre tapped, it requires significant force to tap. This ends you up with a stripped screw 3/4th of the way in because the screw itself fits so bad that it can't lock 100% without some kind of small rubber washer.
Luckily I already had a bag of higher quality carbon steel fan screws that fit these fans much better, but I stripped the first garbage stock screw that it came with and had some difficulty removing it.
The lighting on these isn't very good compared to 2/3 of the other cheaper LED 200m fans I've tried that cost about half as much as these. However, I car far more about function then aesthetics, and these fans are nice and quite like they should be.
Only time will tell now.
the fan space it is very tight and only allows room for a 20mm depth fan. i found that most fans this size - 200mm x 200mm - are 30mm in depth. this was the only fan that came in the 20mm depth at the 200mm size so i bought it.
it is quiet and went in easy.
screw holes lined up perfectly.
personally, i would have preferred a white led, instead of the blue or red that is sold on amazon, but i went with the red and it looks good with the white case.
recommended.
Pros:
Moves air
Fairly quiet
Cons:
Thinner that other fans
Pro/Con(could be either depending what you want):
Pretty bright





