Отзывы о Унитаз с бачком напольный Roca Access 34P23800Y с горизонтальным выпуском
167 отзывов пользователей o Roca Access 34P23800Y с горизонтальным выпуском
Пользовались
Roca Access 34P23800Y с горизонтальным выпуск?
Поделитесь своим опытом и помогите другим сделать правильный выбор
As a very slightly above average DIYER I was worried but my cistern started to run continuously wasting loads of water.
When I removed the old one it turned out the 4x clips had broken off which meant the device was just wobbling around inside the cistern. I found this replacement unit on Amazon and whilst I did not require the full item I simply clipped this unit from the bottom part and clipped it in turning around 6mm to click it in (this did require some force) once it was clipped it was simply a matter of adjusting the bolts to to match your push buttons.
I had to use the old plastic adjustable screws as this device did not come with new ones (unless they are somewhere I did not see)
If I was to do this task again I would purchase a new flush button as mine was a covered in lime inside and made the flush a little rough. These are less than £10 on Amazon.
The unit does have 2x buttons for small and large flushing.
1. Turn water off (just in case)
2. Cut silicone at the rear (if applicable)
3. Remove 2x flush buttons (i used craft knife)
4. Remove Philips plastic screw below the buttons
5. Lift lid and give a little clean
6. Twist old flush system until it clicks then lift upwards.
7. Place the new one inside twisting to click in place
8. Install 2x plastic button leveling screws (i had to adjust 3/4 times until I got my buttons level I would not screw the Philips down until you are happy with them being level
9. Turn Water on
10. Test and always check for leaks everywhere not just on the area you have touched.
Tools used
Philips Screwdriver
Craft knife (removing silicone)
Small normal screwdriver for adjusting the plastic screws.
This one is designed for screw in rods. Some of my Roca cartridges are quite old and are designed to accept triangular rods which have to be cut on the length and then simply slot into place . I do not think it would be possible to convert or adjust the fitting to accept either style.
I was lucky as I hadn't checked my fitting before ordering but it is the correct one and works very smoothly.
PS Item delivered within 24 hours, a bonus if needed urgently.
PPS Ensure you specify single or dual flush type - this one is for the latter.
Would certainly recommend





